| • A built in square pulse generator with two frequency ranges (adjustable, for loads up to 200 mA).
a) Lower range 0,3Hz - 12Hz
b) Higher range 300Hz - 12ΚΗz
• Two (2) circuits for the supply of a pulse triggered by a switch.
a) Constant state “0” and upon triggering “1”
b) Constant state “1” and upon triggering “0”.
• Ten (10) LED indications with a driver circuit, activated at the logic state of “1” that can be driven by an LS TTL output.
• An 8 outputs unit for the supply of the logic “1” with the ability to drive 10 inputs each.
• A BCD to 7 Segment Display Decoder.
• A buzzer with a driver circuit that can be driven by the output of a TTL or LS TTL or CMOS gate.
• A relay with a driver circuit that can be driven by the output of a TTL or LS TTL or CMOS gate with 48V / 5A contacts.
• A built in Logic Probe with the ability to control CMOS, TTL and high frequency pulses. The Logic Probe has a memory circuit for the detection of a short duration pulse.
• A built in power supply unit that provides regulated voltages, with a short circuit electronic protection.
a) 5V / 600 mA
b) Symmetric voltage + - 12V/100 mA
• A Bread-Board with dimensions 10,8 x 16,45 cm, with lines to connect the symmetric voltage integrated in the unit. |
Ελληνικά 
English 
